Download Article

Download Commodity

If you're learning how to use a lace front wig, you've probably been faced with the question of how to get that lace to blend in perfectly with your hairline so information technology's invisible. By applying diverse products, like freeze spray and gel, you can essentially saturate the lace so it clings to your scalp, thus looking like it has melted into your hairline. Information technology may take you lot a few hours to become your wig looking perfect, just with time and practice, yous'll be showing off a gorgeous, natural-looking hairstyle.

Things You lot Should Know

  • Use a freeze spray to secure the lace along your hairline and blow dry your hair to agree it in identify.
  • Place a wrap strip around your hairline for at least 10 minutes to secure the lace.
  • Cut the wrap strip off carefully with fine pair of scissors in a zigzag blueprint to blend the lace into your hairline.
  • Employ hair gel to the remaining edges of the lace and dry the gel with a hairdryer to cure the gel.

  1. 1

    Use a wig cap if you want a layer between the wig and your scalp. A wig cap holds downwards your natural hair and can create a surface for the wig itself to stick to, but some people don't like the way they feel. Also, some wigs come with caps already built-in. If yous are going to employ a wig cap, line upwardly its edge just backside where y'all desire your wig's hairline to exist.[1]

    • If y'all need to buy a wig cap, y'all can get it online or from most beauty supply stores.
    • Wig caps may also exist called stocking caps.

  2. ii

    Line up your wig so the hairline is where you desire it to exist. Pull the lace downward over your forehead to become the hairline in identify, and check its position from all angles to make sure it looks natural. Some wigs also come with straps on the inside that may demand to be adjusted so the wig is neither too tight or too loose.[two]

    • If yous notice it easier to way your wig before you're wearing information technology, you may want to accept a moment to practise that now.

    Advertisement

  3. three

    Use a freeze spray under the lace along the hairline to hold the wig. While belongings the wig in place, lift the lace forepart and glaze your hairline with the freeze spray. Try to spray information technology as shut to your scalp equally possible and so it doesn't get all over your brow.[3]

    • The freeze spray is normally very common cold when it hits your skin, so be prepared!
    • You can purchase freeze spray at your local drug store or online.

  4. 4

    Blow-dry your hairline to secure the wig to the spray. Utilize the medium- or low-heat setting on your blowdryer, and move it slowly dorsum and along over your wig's hairline. Press the lace downwardly onto the freeze spray as y'all dry it so they adhere together.[iv]

    • Avert using high-oestrus, as yous may burn your scalp.

    5. Advertisement

  1. 1

    Put a wrap strip around your hairline for at to the lowest degree 10 minutes. A wrap strip is a thin, stretchy, crepe-similar strip of newspaper that is used to protect your hair and hold your wig in place while the lace is melting into your hairline. To put it on, line information technology up so the center of the wrap covers your hairline around your scalp and necktie information technology off at the nape of your neck.[5]

    • This is a great fourth dimension to work on your makeup, selection out your outfit, or simply relax for a few minutes.
    • It won't hurt anything if the wrap strip stays on for longer. Many people go out them in place while styling their hair and doing their makeup, which tin take over an hour.
    • You tin can purchase wrap strips online or from beauty and cosmetics stores.

    Did You lot Know? When people talk about "melting" their wig lace, they aren't referring to the same kind of melting that often requires a flame or high heat. Information technology simply means that the visible lace is saturated with some kind of product and dried in such a fashion that it "melts" into your hairline and become virtually invisible.

  2. 2

    Remove the wrap strip to reveal the hairline and remaining lace. Once y'all're ready, use a pair of pair of scissors to cut through the wrap strip and throw it abroad. Check your progress by gently pulling the lace upwardly to make sure the wig's hairline is starting to stick to your scalp.[6]

    • If your wig comes correct upward when you pull on it, y'all may want to repeat the freeze spray steps and use more production this time.

  3. 3

    Utilise a fine pair of scissors to trim away the excess lace. Employ a zigzag pattern and cut as shut to your hairline as possible. Continue going over the hairline and cutting away backlog lace until you can't cut away any more. There may still exist some tiny little sections of lace sticking upward, but you lot'll take intendance of those in the next pace.[7]

    • A zigzag blueprint creates a more natural-looking hairline and lets you get closer to the hairline than a straight cutting would.

  4. 4

    Use gel along the edges of the lace with the end of a pin-tail comb. Put a very modest amount of hair gel on the tip of a pivot-tail comb. Printing the gel downwards along the edges of the wig'south hairline so that the remaining small bits of lace are pressed flat against your scalp. Work your way around the entire hairline, reapplying gel to the comb as needed.[8]

    • Using small amounts of gel will hopefully eliminate the risk that the gel will be visible once you're done, though you can always clean upward excess gel with a clammy towel.

  5. 5

    Dry the gel with a hairdryer. Later you lot've melted the residuum of the lace, set your pilus dryer to medium or depression heat and run it dorsum and forth over your hairline. Exam the tackiness of the gel with your finger—if it is nevertheless wet or pasty, proceed drying it until your finger comes abroad dry out to the impact.[9]

    • If you lot wanted to, you could utilize a 2nd wrap strip for 15-20 more than minutes instead of using the hairdryer.

    6. Advertisement

  1. 1

    Make clean upwardly excess gel forth your hairline with a damp towel. Wet a clean hand towel and use a corner of it to gently rub away whatever visible dried gel in front of your hairline. Castor downward away from your hairline toward your face then yous don't mess upwards your wig.[10]

    • Some gels are clear while others are white. The white gel may take a trivial longer to wipe abroad.

  2. 2

    Use an eyebrow razor and gel to create baby hairs to mimic a natural hairline. Utilize a pin-tail comb to pull out a few hairs from the wig all along your hairline. Take your eyebrows razor and shave the hairs so they're about 1⁄2 to 1 inch (1.3 to 2.5 cm) long. Then, use gel and an eyebrow brush to mold them into curls along your brow.[11]

    • Some people like this look and others don't, so do whatsoever feels correct to you lot.

  3. 3

    Employ makeup along your hairline so it blends in with your peel tone. This may not be necessary if the color of the lace perfectly matches your skin tone. If the lace is a different shade, apply your makeup to make the transition from your skin to your hairline await even more seamless. Utilise a petty flake of powder or a minor amount of foundation and blend it into your hairline.[12]

    • Check the color of your part, likewise. You may want to apply foundation to the function and then that it matches your skin tone.

  4. iv

    Use a hot comb to lay downward your wig for a flat, sleek style. If your wig is too voluminous and doesn't lay as close to your scalp as yous similar, run the back of a hot comb over small 3 to 4 inches (seven.6 to x.2 cm) sections of your hair along your part. Use medium heat so you don't accidentally fire your scalp, and keep moving the hot comb rather than holding it down in one place. Button downwards with the comb so the oestrus flattens your hair.[13]

    • The hot comb more often than not works a niggling bit meliorate than a straightener because it lets yous push your hair down toward your scalp. With a straightener, you lot even so take infinite between your pilus and scalp.

    5. Advertisement

Inquire a Question

200 characters left

Include your email address to go a message when this question is answered.

Submit

Advertizing

  • If you accept a lot of natural hair that needs to become nether the wig cap, endeavour braiding it into cornrows then it's as close to your scalp as possible.[14]

Thanks for submitting a tip for review!

Advertisement

Things You'll Need

  • Wig cap
  • Wig
  • Freeze spray
  • Hairdryer
  • Wrap strips
  • Scissors
  • Gel
  • Pin-tail comb
  • Towel
  • Hot comb
  • Eyebrow razor
  • Eyebrow brush
  • Makeup

References

Most This Article

Thanks to all authors for creating a page that has been read 24,097 times.

Did this article help y'all?